I can not find any references to what the external dimensions of the shaft splines should be. I have a copy of the 28th edition Machinery's Handbook, but can only find dimensional information regarding the internal splines (specifically for broached holes). The slack adjuster mates to the shaft by a 1.5" - 10C SAE spline. The slack adjuster acts as a lever arm to rotate a shaft which engages the brake pad to the rail wheel. I'm designing an air brake system for a railroad application which will use automatic slack adjusters which are typically found on over the road trucks/trailers. Intermittent: 4,121 Lb-In.After several years of referencing this website, I've decided to post a question I haven't been able to find an answer to. Replacement Short Cap Screw (Mounting End) - Sold Separately:Ġ09, 008 & 007 Design - 16292-088 - 4 Required REPLACEMENT RACE, THRUST BEARING - SOLD SEPARATELY:Ġ09, 008 & 007 Design - 7462-000 - 1 Required REPLACEMENT PLATE, SPACER - SOLD SEPARATELY:Ġ09, 008 & 007 Design - 7358-000 - 1 Required
Replacement Output Shaft - Sold Separately:Ġ09, 008 & 007 Design - 7360-002 - 1 Required Replacement Mounting Flange - Sold Separately:Ġ09 & 008 Design 22000-001, 007 Design 7463-000 - 1 Required REPLACEMENT LONG CAP SCREW (CAP END) - SOLD SEPARATELY: REPLACEMENT BEARING, THRUST NEEDLE - SOLD SEPARATELY:Ġ09, 008 & 007 Design - 7537-000 - 1 Required
RECOMMENDED MAXIMUM SYSTEM OPERATING TEMPERATURE: Premium Quality, Anti-Wear Type Hydraulic Oil With A Viscosity Of Not Less Than 701 Sus Or 13Cst With Best Range Of 100 - 200 Sus Or 20 - 43 Cst At Operating Temperature, Intermittent Operation - 10 Percent Of Every Minute / Peak Operation - 1 Percent Of Every MinuteĬontinuous: 1,350 psi / Intermittent 1,800 psi Intermittent: 3,430 Lb-In.Ĭontinuous Rating - Motor May Be Run Continuously At These Ratings.
Be Sure Motor Is Filled With Fluid Prior To Any Load Applications.Ĭontinuous: 15 gpm / Intermittent: 20 gpmĬontinuous: 2,500 Lb-In. To Assure Best Motor Life, Run Motor For Approximately One Hour At 30 Percent Of Rated Pressure Before Application To Full Load. 00 Sae 6B Spline With 1/4-20 Threaded Hole G 1/4 Port (End Cap) Accepts Fittings With Elastomeric Or Deformable Metallic Sealing Member Per Din 3852Ģ Bolt Std: 82.6. British Standard Pipe (BSP) G 1/4 Port (End Cap)
0 kommentar(er)
